NOTE: None of the products, protocols or methods here have been approved by Jim Humble or the Genesis II Church : This is the research forum and was set up by the Genesis 2 Church for those wanting to discuss and experiment with MMS, other Church Sacraments and new complimentary technologies. Any experimentation that you personally do is at your own risk. Full disclaimer.

MMS Chlorine Dioxide (CLO2) Concentration Using Different Acid Activators & Time

  • CLO2
  • CLO2's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
  • Website:
2 years 9 months ago #13 by CLO2

Testing procedure:
1. Add 3 drops of 22.4% Sodium Chlorite Solution to a small glass beaker that is tilted to pool the solution to the low point.
2. Add 3 drops of acid activator to the beaker and start timer.
3. Gently agitate during the activation period.
4. When the activation period ends, pour some distilled water (DW) from a prepared 120 ml stock supply into the small activation beaker.
5. Pour that solution back into the stock DW supply and repeat again.
6. Stir well to disperse the ingredients equally throughout the 120 ml solution.
6. Withdraw 1 ml from the 120 ml MMS solution and add to 9 ml of DW in a beaker.
7. Stir/swirl the 10 ml diluted MMS solution and withdraw 4 ml which will be measured for CLO2 concentration using an eXact Chlorine photometer using appropriate reagents and a conversion chart.

Notes on vinegar activators
Two tests with vinegars were made @ 1:5 activated 3 minutes. One with organic Braggs & one with Heinz distilled white. Results were respectively: 1.5 & 0.0 ppm.

2 ml of 3000 ppm original CDS equals a 1 drop MMS1 dose in a normal stomach
Websites: *
YouTube Instructional Videos:
Answers to many questions are in Jim Humble's books:
The following user(s) said Thank You: Scott_McRae

Please Log in to join the conversation.

Time to create page: 0.220 seconds
Go to top