NOTE: None of the products, protocols or methods here have been approved by Jim Humble or the Genesis II Church : This is the research forum and was set up by the Genesis 2 Church for those wanting to discuss and experiment with MMS, other Church Sacraments and new complimentary technologies. Any experimentation that you personally do is at your own risk. Full disclaimer.

CDH and CDS: Brushing Teeth With It

More
1 year 4 months ago #271 by Scott_McRae
The following is what I believe to be a better way of using CLO2 to better take care of oral problems.

First of all, in order to deactivate pathogens in general with CLO2, there are a few things we should always keep in mind:

-1. Concentration - The more concentrated the CLO2 in solution, the quicker and easier the pathogens will be deactivated.
-2. Turbidity - The more particles there are in a medium, the less effective the the CLO2 will be.
-3. Temperature - The warmer the solution is, the more effective the CLO2 will be. For example an equivalent ppm CLO2 solution used at refrigerator temperatures will be far less effective than one used at 41 degrees C (106 degrees F).

So based on the above, here's what I believe to be a much more effective way of using CLO2 to take care of our oral hygiene:

-1. Either make a batch of CDH (3.5mg per ml) or CDS (3.0mg per ml) ideally using HCl instead of citric acid. This will give you a much higher ppm per drop of MMS used to make either product and if you are able to make the CDH with HCl instead of citric acid, it will taste and feel much better in your mouth too.
-2. Before brushing, floss your teeth (at least once a day) to reduce the amount of debris in your mouth and to open up the gaps between your teeth and then rinse your mouth well with water too, before going to the next step.
-3. Put 100ml of warm water (as in 38 to 41 degrees C or 100 to 106 degrees F) in a glass and then add 2ml of either the CDH or CDS to the nice warm water. (2ml of CDH will give you about 7mg of CLO2 and 2ml of CDS at 3mg per ml (3000ppm) will give you 6mg)
-4. Immediately (before the water cools down) sip in a small amount of the water (about 15-20ml) and swish this all around your mouth, trying to force it between your teeth, etc. for about 10 seconds and then spit it out.
-5. Then take another 15-20ml sip and while holding it in your mouth, brush your lower teeth and gums thoroughly.
-6. Take another sip and do the same with your upper teeth and gums.
-7. Take another sip and thoroughly brush your tongue, going as far back as you can until it just about makes you gag (we want to get that bacteria the hides out at the very back of your tongue as much as possible so it won't repopulate later on).
-8. Take the remaining amount and gargle with it for about 5 seconds to get to the very back of your mouth.
-9. Do the above 2 to 3 times a day for a week. If you still have the coated tongue after a week, increase to 3ml of either CDH or CDS in the 100ml of warm water and repeat for another week. If even that doesn't work, and you can handle it, increase to 4ml in the 100ml of warm water - but this amount is pretty strong so be careful.

I believe that not only will the above work much better than the present teeth brushing protocol which Jim has laid out, but it will also taste and feel a lot better in the mouth because of using HCl instead of citric acid, if its available.

By the way, I have been brushing my teeth as above twice a day for about 3 years now. The only difference being that for about the last 6 months, I have reduced to just 1ml of CDH per 100ml of warm water because for my needs, I think 1ml is sufficient if there aren't any serious issues going on orally, which I don't have.

If you'd like to understand why I'm saying what I'm saying about concentration, turbidity and temperature of water and their affect on how CLO2 works to deactivate bacteria, read the following document which explains the importance of all 3 in deactivating bacteria in produce:

File Attachment:

File Name: CLO2dose,w...fect.pdf
File Size:175 KB


If any of you do use the method which I've described above, please let us know how it works (or doesn't work) for you. We all need to know.

Hope this helps,
Scott

Scott McRae
Website: www.MMSinfo.org
Facebook: www.facebook.com/cdhinfo
[/size][/b]
Attachments:

Please Log in to join the conversation.

Time to create page: 0.239 seconds
Go to top